Forge Motorsport Forge Logo Stencil FMLS

This plastic sheet stencil can be used to spray or paint on the Forge logo onto an intercooler and more!

For the best result:

• Use masking tape to secure the stencil in a fixed position, double check the location and cover any other components you do not wish to get paint on (fenders, bumpers, reservoirs etc). 
• Spray the paint about 300mm away from the stencil. For the best finish, apply two or three thin layers - This will give an even paint coverage and avoid runs.
• Wait for the paint to dry between layers.
• Wait for paint to dry completely and remove stencil.

*Forge Motorsport accept no responsibility for damage caused by improper use and/or installation of our products*

Logo Dimensions: 
320mm x 125mm

Plastic Sheet Dimensions: 
450mm x 320mm 

Please check the part number, vehicle details and available options before ordering. Contact TSR Performance for fitment advice.